MSTS BIN REPLACEMENT ENG FILES FOR NSW CPH RAILMOTORS ----------------------------------------------------- These replacement eng files will correct the lighting for the CPH railmotors to enable correct lighting when running in both directions. THE FOLLOWING ITEMS MUST BE INSTALLED ------------------------------------- MSTS Train Simulator MSTS BIN version 1.8.0521. These eng files may work under earlier versions of BIN but have not been tested. THESE ENG FILES WILL CAUSE ERRORS IF YOU DO NOT HAVE MSTS BIN INSTALLED. Original 3D model of CPH RailMotor - by Joseph Spinella NSW CPH RailMotor Upgrade PackV2.zip by Brian Bere-Streeter CPH_KMH_CABVIEW.zip or CPH_MPH_CABVIEW.zip by Jim Halsey The CPH railmotors and cabviews must be tested and running correctly before installing these eng files. Unzip the files into a temporary folder, then copy and paste the relevant files straight into the existing CPH folder (check the name to be sure) - over-write any existing files when it asks, as some of the original files have been enhanced. There are only four files in this zip, direct replacement files for the eng files, cph-7.eng, cph-22.eng, cph-25.eng and cph.eng. These eng files are setup for Reverse running, and correct bi-directional lighting. To reverse the railcars and change cabs, the following procedure must be adhered to: FOR A SINGLE RAILCAR. When running in the Forward direction, close the Throttle, and using the brakes bring the locomotive to a full stop. Press the view 1 key to change to the other cab. You are now facing in the other direction. FOR MULTIPLE UNIT RUNNING. When running in the Forward direction, close the Throttle, and using the brakes bring the locomotive to a full stop. Press the S key to put the locomotive into neutral, now press the F9 function key to bring up the TRAIN OPERATIONS window. Select the Railcar that you want to drive and then press the View 1 key - this will change the view to the rear driving cab, then close the TRAIN OPERATIONS window by pressing the F9 function key again. Place the locomotive into Forward, release the brakes, then press the D key to drive away. NOTE: when using the BIN reverse cab feature, when you are running in 'reverse' and want to change the points in front of you, just press the G key normally, DO NOT press Shift G as you would normally do when not using BIN. If you have any problems installing this add-on, please e-mail me at jhalsey@optusnet.com.au Legal Information: ------------------ These eng files modified by Jim Halsey. Microsoft, Train Simulator and all other names and logos associated with that product remain the property of Microsoft. Any logos used within the textures of this model remain the property of their respective owner. Disclaimer: ----------- This add-on is unofficial and I am not not affiliated in any way with Microsoft. All files associated with this product are provided "as is" and do not come with any sort of warranty whatsoever. I assume that any person using this add-on and its associated files has the necessary knowledge to install and use this software correctly. I am not responsible for any damage and/or loss to you, your data, your equipment or any other property or persons from using (or misusing) this add-on and its associated files. This product is to be USED AT YOUR OWN RISK. By installing this product, you are accepting your agreement to the statements contained within this readme file.