Australia
New South Wales Government Railways

Class 41 Diesel Locomotives Cabview

for Microsoft Train Simulator.
---------------------------------------------

Downloaded from The Short North Carriage and Wagon Engineering Workshops
http://shortnorth.steam4me.net/

Credits:
--------

Cab view by Jim Halsey.
e-mail: jhalsey@optusnet.com.au

Some graphics - brake stand and lever graphics - courtesy of Christine Sweetnam.

Installation:
-------------

There is only one Version of this cab: Imperial (Miles per Hour) speedometer.

To use this Cabview pack, you MUST HAVE Brian Bere-Streeter's original Class 41 
locomotives pack installed in an existing folder named  <<<   AU_NSWGR_41   >>>.

Delete all existing files in the existing Cabview folder under <<  AU_NSWGR_41  >>.
Unzip the new files into a temporary folder, then copy and paste all of the files
straight into the <<<   Cabview   >>> folder, under the Trainsets
<<<   AU_NSWGR_41   >>> folder (check the name to be sure).

In the updated Cabview folder you will find NEW .eng files for the four 41 class 
locomotives - to ensure that they use the new Cabviews, Move or Copy these four 
files from the Cabview folder into the AU_NSWGR_41 folder, over-writing the existing files.

The new files will directly replace the existing Cabview without further installation.

If you have any problems installing this add-on, please e-mail me at
jhalsey@optusnet.com.au

SPECIAL FEATURE FOR MSTS BIN USERS ONLY
=======================================

If you have MSTS BIN installed on your system, these Cabviews are setup for Reverse running.

To reverse the locomotive and change cabs, the following procedure must be adhered to:

When running in the Forward direction, close the Throttle, and using the brakes bring the 
locomotive to a full stop. Press the S key to put the locomotive into neutral, now press 
the View 1 key (DO NOT change the Reverser from Forward to Reverse) - this will change the 
view to the rear driving cab. Place the locomotive back into Forward, release the brakes, 
then press the D key to drive away. NOTE: when using the BIN reverse cab feature, when you 
are running in 'reverse' and want to change the points in front of you, just press the 
G key normally, DO NOT press Shift G as you would normally do when not using BIN.

Legal Information:
------------------

This cab view is © 2010 Jim Halsey.

This cab view is free to download and use for personal non-profit 
use. Any other use of this cab view without my permission is 
strictly forbidden. In addition, this cab view is not to be modified
and/or re-distributed without my permission. If you would like to 
modify and/or re-distribute this cab view, please e-mail me first 
to discuss the terms and conditions.

Microsoft, Train Simulator and all other names and logos associated 
with that product remain the property of Microsoft. 

Any logos used within the textures of this model remain the property 
of their respective owner.

Disclaimer:
-----------

This add-on is unofficial and I am not not affiliated in any way with 
Microsoft.

All files associated with this product are provided "as is" and do
not come with any sort of warranty whatsoever. I assume that any person 
using this add-on and its associated files has the necessary knowledge 
to install and use this software correctly. I am not responsible for
any damage and/or loss to you, your data, your equipment or any other 
property or persons from using (or misusing) this add-on and its 
associated files. This product is to be USED AT YOUR OWN RISK.

By installing this product, you are accepting your agreement to
the statements contained within this readme file.